Limits...
Impact of Data Processing and Antenna Frequency on Spatial Structure Modelling of GPR Data.

De Benedetto D, Quarto R, Castrignanò A, Palumbo DA - Sensors (Basel) (2015)

Bottom Line: The results showed that the type and range of spatial structures of GPR data did not depend on data processing at a given frequency.It was also evident that the noise tended to decrease with the complexity of processing, then the most error-effective procedure was selected.The results highlight the critical importance of the antenna frequency and of the spatial scale of soil/subsoil processes being investigated.

View Article: PubMed Central - PubMed

Affiliation: Dipartimento di Scienze della Terra e Geoambientali, University of Bari, Aldo Moro, Bari 70125, Italy. daniela.debenedetto@entecra.it.

ABSTRACT
Over the last few years high-resolution geophysical techniques, in particular ground-penetrating radar (GPR), have been used in agricultural applications for assessing soil water content variation in a non-invasive way. However, the wide use of GPR is greatly limited by the data processing complexity. In this paper, a quantitative analysis of GPR data is proposed. The data were collected with 250, 600 and 1600 MHz antennas in a gravelly soil located in south-eastern Italy. The objectives were: (1) to investigate the impact of data processing on radar signals; (2) to select a quick, efficient and error-effective data processing for detecting subsurface features; (3) to examine the response of GPR as a function of operating frequency, by using statistical and geostatistical techniques. Six data processing sequences with an increasing level of complexity were applied. The results showed that the type and range of spatial structures of GPR data did not depend on data processing at a given frequency. It was also evident that the noise tended to decrease with the complexity of processing, then the most error-effective procedure was selected. The results highlight the critical importance of the antenna frequency and of the spatial scale of soil/subsoil processes being investigated.

No MeSH data available.


Maps of estimated amplitude for 250 MHz (a); 600 MHz (b) and 1600 MHz (c) frequencies using the first processing procedure corresponding to their maximum depth investigated. (Colour scale uses iso-frequency classes).
© Copyright Policy
Related In: Results  -  Collection

License
getmorefigures.php?uid=PMC4541886&req=5

sensors-15-16430-f006: Maps of estimated amplitude for 250 MHz (a); 600 MHz (b) and 1600 MHz (c) frequencies using the first processing procedure corresponding to their maximum depth investigated. (Colour scale uses iso-frequency classes).

Mentions: As regards the first procedure at 250 MHz frequency, the visual inspection of the estimated normalized amplitude maps at the different times showed that the processing did not modify sensibly the signal at any depth, preserving the raw information. However, the signal in depth was not usable because of the high attenuation (Figure 6a). For both 600 and 1600 MHz antenna, the maps were very noisy and did not showed well defined spatial structures (Figure 6b,c).


Impact of Data Processing and Antenna Frequency on Spatial Structure Modelling of GPR Data.

De Benedetto D, Quarto R, Castrignanò A, Palumbo DA - Sensors (Basel) (2015)

Maps of estimated amplitude for 250 MHz (a); 600 MHz (b) and 1600 MHz (c) frequencies using the first processing procedure corresponding to their maximum depth investigated. (Colour scale uses iso-frequency classes).
© Copyright Policy
Related In: Results  -  Collection

License
Show All Figures
getmorefigures.php?uid=PMC4541886&req=5

sensors-15-16430-f006: Maps of estimated amplitude for 250 MHz (a); 600 MHz (b) and 1600 MHz (c) frequencies using the first processing procedure corresponding to their maximum depth investigated. (Colour scale uses iso-frequency classes).
Mentions: As regards the first procedure at 250 MHz frequency, the visual inspection of the estimated normalized amplitude maps at the different times showed that the processing did not modify sensibly the signal at any depth, preserving the raw information. However, the signal in depth was not usable because of the high attenuation (Figure 6a). For both 600 and 1600 MHz antenna, the maps were very noisy and did not showed well defined spatial structures (Figure 6b,c).

Bottom Line: The results showed that the type and range of spatial structures of GPR data did not depend on data processing at a given frequency.It was also evident that the noise tended to decrease with the complexity of processing, then the most error-effective procedure was selected.The results highlight the critical importance of the antenna frequency and of the spatial scale of soil/subsoil processes being investigated.

View Article: PubMed Central - PubMed

Affiliation: Dipartimento di Scienze della Terra e Geoambientali, University of Bari, Aldo Moro, Bari 70125, Italy. daniela.debenedetto@entecra.it.

ABSTRACT
Over the last few years high-resolution geophysical techniques, in particular ground-penetrating radar (GPR), have been used in agricultural applications for assessing soil water content variation in a non-invasive way. However, the wide use of GPR is greatly limited by the data processing complexity. In this paper, a quantitative analysis of GPR data is proposed. The data were collected with 250, 600 and 1600 MHz antennas in a gravelly soil located in south-eastern Italy. The objectives were: (1) to investigate the impact of data processing on radar signals; (2) to select a quick, efficient and error-effective data processing for detecting subsurface features; (3) to examine the response of GPR as a function of operating frequency, by using statistical and geostatistical techniques. Six data processing sequences with an increasing level of complexity were applied. The results showed that the type and range of spatial structures of GPR data did not depend on data processing at a given frequency. It was also evident that the noise tended to decrease with the complexity of processing, then the most error-effective procedure was selected. The results highlight the critical importance of the antenna frequency and of the spatial scale of soil/subsoil processes being investigated.

No MeSH data available.