Limits...
Investigation of photocatalytic degradation of phenol by Fe(III)-doped TiO2 and TiO2 nanoparticles.

Hemmati Borji S, Nasseri S, Mahvi AH, Nabizadeh R, Javadi AH - J Environ Health Sci Eng (2014)

Bottom Line: In addition, the effects of various operational parameters on photocatalytic degradation, such as pH, initial concentration of phenol and amount of photocatalyst were examined and optimized.At all different initial concentration, highest degradation efficiency occurred at pH = 3 and 0.5 g/L Fe(III)-doped TiO2 dosage.With increase in initial concentration of phenol, photocatalytic degradation efficiency decreased.

View Article: PubMed Central - HTML - PubMed

Affiliation: Department of Environmental Health Engineering, School of Public Health and Center for Water Quality Research (CWQR), Institute for Environmental Research (IER), Tehran University of Medical Sciences, Tehran, Iran.

ABSTRACT
In this study Fe (III)-doped TiO2 nanoparticles were synthesized by sol-gel method at two atomic ratio of Fe/Ti, 0.006 and 0.034 percent. Then the photoactivity of them was investigated on degradation of phenol under UV (<380 nm) irradiation and visible light (>380 nm). Results showed that at appropriate atomic ratio of Fe to Ti (% 0.034) photoactivity of Fe(III)-doped TiO2 nanoparticles increased. In addition, the effects of various operational parameters on photocatalytic degradation, such as pH, initial concentration of phenol and amount of photocatalyst were examined and optimized. At all different initial concentration, highest degradation efficiency occurred at pH = 3 and 0.5 g/L Fe(III)-doped TiO2 dosage. With increase in initial concentration of phenol, photocatalytic degradation efficiency decreased. Photoactivity of Fe (III)-doped TiO2 under UV irradiation and visible light at optimal condition (pH = 3 and catalyst dosage = and 0.5 g/L) was compared with P25 TiO2 nanoparticles. Results showed that photoactivity of Fe(III)-doped TiO2 under visible light was more than P25 TiO2 photoactivity, but it was less than P25 TiO2 photoactivity under UV irradiation. Also efficiency of UV irradiation alone and amount of phenol adsorption on Fe(III)-doped TiO2 at dark condition was investigated.

No MeSH data available.


Related in: MedlinePlus

Comparison of photoactivty of Fe(III)-doped TiO2 and P25 TiO2 nanoparticles under UV and visible light.
© Copyright Policy - open-access
Related In: Results  -  Collection

License 1 - License 2
getmorefigures.php?uid=PMC4125378&req=5

Figure 8: Comparison of photoactivty of Fe(III)-doped TiO2 and P25 TiO2 nanoparticles under UV and visible light.

Mentions: Figure 8 shows comparison of photoactivty of Fe(III)-doped TiO2 nanoparticles with two different content of Fe and P25 TiO2 nanoparticles under UV irradiation and visible light on photocatalytic degradation of phenol at optimum condition (pH = 3, catalyst dosage = 0.5 g/L). As shown in the figure, the degradation rate of phenol under Fe(III)-doped TiO2/Vis was higher than degradation rate under TiO2/Vis. This observation confirms that Fe(III) ions play an improvement role in TiO2 structure and increases activity of TiO2 to visible light.


Investigation of photocatalytic degradation of phenol by Fe(III)-doped TiO2 and TiO2 nanoparticles.

Hemmati Borji S, Nasseri S, Mahvi AH, Nabizadeh R, Javadi AH - J Environ Health Sci Eng (2014)

Comparison of photoactivty of Fe(III)-doped TiO2 and P25 TiO2 nanoparticles under UV and visible light.
© Copyright Policy - open-access
Related In: Results  -  Collection

License 1 - License 2
Show All Figures
getmorefigures.php?uid=PMC4125378&req=5

Figure 8: Comparison of photoactivty of Fe(III)-doped TiO2 and P25 TiO2 nanoparticles under UV and visible light.
Mentions: Figure 8 shows comparison of photoactivty of Fe(III)-doped TiO2 nanoparticles with two different content of Fe and P25 TiO2 nanoparticles under UV irradiation and visible light on photocatalytic degradation of phenol at optimum condition (pH = 3, catalyst dosage = 0.5 g/L). As shown in the figure, the degradation rate of phenol under Fe(III)-doped TiO2/Vis was higher than degradation rate under TiO2/Vis. This observation confirms that Fe(III) ions play an improvement role in TiO2 structure and increases activity of TiO2 to visible light.

Bottom Line: In addition, the effects of various operational parameters on photocatalytic degradation, such as pH, initial concentration of phenol and amount of photocatalyst were examined and optimized.At all different initial concentration, highest degradation efficiency occurred at pH = 3 and 0.5 g/L Fe(III)-doped TiO2 dosage.With increase in initial concentration of phenol, photocatalytic degradation efficiency decreased.

View Article: PubMed Central - HTML - PubMed

Affiliation: Department of Environmental Health Engineering, School of Public Health and Center for Water Quality Research (CWQR), Institute for Environmental Research (IER), Tehran University of Medical Sciences, Tehran, Iran.

ABSTRACT
In this study Fe (III)-doped TiO2 nanoparticles were synthesized by sol-gel method at two atomic ratio of Fe/Ti, 0.006 and 0.034 percent. Then the photoactivity of them was investigated on degradation of phenol under UV (<380 nm) irradiation and visible light (>380 nm). Results showed that at appropriate atomic ratio of Fe to Ti (% 0.034) photoactivity of Fe(III)-doped TiO2 nanoparticles increased. In addition, the effects of various operational parameters on photocatalytic degradation, such as pH, initial concentration of phenol and amount of photocatalyst were examined and optimized. At all different initial concentration, highest degradation efficiency occurred at pH = 3 and 0.5 g/L Fe(III)-doped TiO2 dosage. With increase in initial concentration of phenol, photocatalytic degradation efficiency decreased. Photoactivity of Fe (III)-doped TiO2 under UV irradiation and visible light at optimal condition (pH = 3 and catalyst dosage = and 0.5 g/L) was compared with P25 TiO2 nanoparticles. Results showed that photoactivity of Fe(III)-doped TiO2 under visible light was more than P25 TiO2 photoactivity, but it was less than P25 TiO2 photoactivity under UV irradiation. Also efficiency of UV irradiation alone and amount of phenol adsorption on Fe(III)-doped TiO2 at dark condition was investigated.

No MeSH data available.


Related in: MedlinePlus